Topics created by mmueller70

@mmueller70 I'm glad it worked. We've now released 3.5.2-rc.1 in which this bug has been fixed.

@mmueller70 it's as @deckingman says, you can use a common positive wire for all fans that use the same supply voltage. The thermistor cannot share a ground wire with anything else except another thermistor, because Duet boards use separate analog and digital grounds in order to provide better accuracy and less noise in the readings.

@mmueller70 why do you need to enter GCodes manually? Would it suffice to be able to run a few fixed GCodes, for example to feed or retract filament?

@dc42

Again and again I realize how good it was to choose a Duet board. If I miss a function, it's not because it doesn't exist, but because I can't find it in the multitude of functions.

Thanks

@oliof

You made my day!

Updated to 3.4b6 and it works again!
Thank you very much.

Hi!

No, the driver does not get hot, it stays colder than the others in use. I think its internal heat measurement is damaged. Immediately after switching on, the overtemperature is reported. The M569 command solves my problem. Maybe I'll upgrade to Duet3 someday ...

Thanks for your help!