Topics created by Mobietec

@mobietec said in duet3 tool board:

Duet 3 MB6HC v0.6 or 1.0 FIRMWARE_VERSION: 3.0

@mobietec said in duet3 tool board:

Duet TOOL1LC firmware version 3.3beta2+2

Your toolboard and main firmware are not the same.

You should probably be using 3.3 all around.

Upload this zip file as is to the system tab in DWC
https://github.com/Duet3D/RepRapFirmware/releases/download/3.3/Duet2and3Firmware-3.3.zip

and then check the installed versions with M115 and M115 B121 again after rebooting to see if it took.

If it did, great. If not, upload the zip file again and check again. If it's just the toolboard that isn't updating, send M997 B121 to flash the toolboard.

It's been resolved.

@mobietec thank you all i did my first test print today only a cube it not looking too bad need to sort out ressur or liner advance nexr but getting their