Posts made by owling2005

@droftarts i have a standard duet 2 wifi i ordered the ethernet module and get a replacement wifi aswell

Thanks for your kind words i wish more members were as considerate

the scrathces happened after the fact as I was thinning cables for the pins for the connector and a blob of solder fell on there I do have a possible friend able to possible desolder the board but if we do that I'll go ethernet as the wifi was patchy at best board would restart but wifi would fail to connect

@jay_s_uk i made sure it was free it was just the weight of the cable cause I couldn't disconnect it because of its poor placement

@Phaedrux no i mounted it into my ender 5+ middle section connected all the wires turned it over and it was gone I was fuming its such a bad design these no support or anything for it

@elmoret it wasnt physicalie damaged it looked like the connector was just glued on

@jay_s_uk ur answers as good as mine

@jay_s_uk 

@owling2005 said in duet 2 wifi wifi connector fell off * warrenty request e3d *:

Reply for jay as I cant find the reply button * this is the best photo I can produce its off my phone I have no other way to take a photo

Reply for jay as I cant find the reply button * this is the best photo I can produce its off my phone I have no other way to take a photo

as e3d have sent me here for you to try and help me the connector fell off while mounting the board into the case

• Reply for jay as I cant find the reply button * this is the best photo I can produce its off my phone I have no other way to take a photo