Hi all,
So I have issued now M303 T0 S220....
Everything goes ok-ish; and after 24 minutes of 'tuning', I got:
Warning: heater behaviour was not consistent during tuning
Auto tune starting phase 4, measuring with fan on
This happens to both my hotend and my bed. Bed is AC powered by a relay.
Any help/advice?
Tinus
@Phaedrux Oh brother, rookie mistake. Broken wire. Tested continuity and then realized it was broken - I'm such an idiot!
A bit of a different Q, but still on this (kinda); what AWG wire do you use for the end stops? (And for the rest of the electronics?)
@droftarts Hi!
Thank you very much! 
Sometimes I just need to explore a bit more hahaah
Wishing you an awesome day,
Tinus
@Phaedrux Cool thank you Will have a look at it - I suspect the wire I was/am using is too thin - where I crimp it, sometimes it brakes off - and that means looking for trouble. The other wire I have is too thick - wonderful living in Africa!
PLEASE mark this also as Solved?
Eureka!
G32
Manual corrections required: 0.00 turn up (0.00mm) 0.00 turn down (0.00mm) 0.76 turn up (-0.38mm) 0.81 turn up (-0.41mm)
The M671 I used to define the springs positions was not correct.
Hi,
Sometimes due to mechanical reasons (and the wonderful accuracy of my build) I experience that some of the 3 Z axis goes out of 'alignment' - so it inadvertently tilts the bed. Is there perhaps a G-code that I can issue to let me move one of the Z stepper motors? I will make maintenance (greasing and cleaning the lead screws) a lot easier too!
Any/all help appreciated!
Tinus
@jay_s_uk Thank you! Got it working 100% Can you perhaps mark this post as SOLVED?