Posts made by Richygoat

Yes that is correct. The 12V/24V is only for the Button LED. Yes i can turn the Printer via Web Interface off.

This is how it works perfekt. Big thanks to Eryion from Rics 3D Discord.

Is something like this possible?

Ok the PS_ON pin will be connected to Ground when the PSU have to be enabled. Is there a way to get a 5v Signal to shut the Relay down? See the picture attached.

Here is no answer to this question. I want to turn the PSU off with this modul. When it get 5v continuously from the Duet it stays always on. When there is 5v, GND an PS_ON on that connector how does it exactly work. I know this is 5v in. Does the PS_ON switch the 5V to PS_ON?

Hello, did anybody the Lerdge Power Modul to work with the Duet. I want to try the same thing. Have a Lerdge Power Modul laying around here. What does the PS_ON pin on the Duet exactly? Act it like a 5v on and off switch?

It is a CoreXY Printer. Sapphire Plus.

Hello, ringing is strange. It is one the complete side of the cube. Also above the x and y latters. Here is my config.g file.config.g

Hello, i have a problem with the quality after installing the Duet Wifi into my Corey Printer. It was a MKS Robin Nano v1.2 installed before and the surface was ok. Now after installing the Duet it is terrible. Everything works fine but the surface is so bad. Take a lock at the pictures. Maybe someone can help me. By the way i changed nothing on the hardware and it was the same Gcode file then before.

Hello,
i'm new to the Duet Board and i'm actually building a V-King Printer and want to use the Duet Maestro board. As far as good. Most things are running. But i always get error messages when i move the axis.

Please see the picture attached. What could cause the failure?

Thanks for the help.

regards
Christian