Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. rmriggin
    3. Topics
    • Profile
    • Following 0
    • Followers 0
    • Topics 4
    • Posts 23
    • Best 0
    • Controversial 0
    • Groups 0

    Topics created by rmriggin

    • rmrigginundefined

      Heaters stuck on

      Duet Hardware and wiring
      • • • rmriggin
      10
      0
      Votes
      10
      Posts
      1.0k
      Views

      dc42undefined

      U2 on Duet WiFi revision 1.04 is AP7361C-33E-13. It's different (and not compatible) on some earlier revisions.

    • rmrigginundefined

      Bed temp sensor issues

      Duet Hardware and wiring
      • • • rmriggin
      3
      0
      Votes
      3
      Posts
      505
      Views

      rmrigginundefined

      @dc42 the hotend temp reads lower than it should currently sitting in room where ambient is about 68F it's reading at 0 to -1-2 C. I used the default values for the firmware thermistor config at the duet firmware config page. The bed temp sensor values are between 80-90C regardless of whether there is a sensor connected or not. When sensor is disconnected for hotend it reads the expected 2000F.

    • rmrigginundefined

      CoreXY movement issues 1.21

      Tuning and tweaking
      • • • rmriggin
      3
      0
      Votes
      3
      Posts
      600
      Views

      dc42undefined

      If X and Y jog in the correct directions but Y homes the wrong way, that implies that your homall.g and homey.g files are homing Y the wrong way.

      Looking at the front of your printer, which directions are +x and +y, and where are your endstop switches located?

    • rmrigginundefined

      Not booting or reading SD after update

      Firmware installation
      • • • rmriggin
      11
      0
      Votes
      11
      Posts
      1.3k
      Views

      dc42undefined

      Then perhaps it is time for a warranty inquiry. Email your supplier.