Best posts made by sgtconker1r

This is my modified FLSUN Q5.
It features a Slice Engineering Mosquito hotend and a Duet 2 Wifi.
Firmware 3.4.4

For the setup to work I needed to design and print new cooling ducts, new bed level extension and part cooling fan holder. The holder includes an extra piece to keep the bowden tube aligned as it goes into the hot end. The mosquito is using a machined adapter from 713Maker.

Video:
https://youtu.be/rswph5SLrJk

As of right now I have no intentions of using mag balls or a smart effector on this machine. Perhaps in the future.

NOTE: This machine used to run Klipper with the old board. But that old board, well, lets just say I ran it too hard, too fast, for too long. Hence the need for a new board.

@dc42

Quote: "...make sure the endstops are consistent with the motors. Looking at the machine from the front, the X tower should be on the left, the Y tower on the right and the Z tower at the back."

This is what was wrong with my setup.

It seems the wiring was mislabeled from the very beginning.

Now the homing works correctly.

Solved.