Topics created by sgtconker1r

@dc42

It could print much faster, but this particular orange PETG looks like trash when gets printed at speeds above 70mm/s. It just doesn't like the speed. (probably because it was super cheap) 😉

The retraction speed is currently set to 40mm/s, it does seem a bit slow, this might be due to the 1:1 ratio on the extruder itself. It's a Micro Swiss all metal bowden extruder.

I'll play around with the settings.

@dc42

Quote: "...make sure the endstops are consistent with the motors. Looking at the machine from the front, the X tower should be on the left, the Y tower on the right and the Z tower at the back."

This is what was wrong with my setup. PXL_20221111_014900914.jpg

It seems the wiring was mislabeled from the very beginning.

Now the homing works correctly.

Solved.