Best posts made by siblues

I had some motors on the way so I tried what Tony mentioned and it was a bad motor.

Try following this step by step

https://duet3d.dozuki.com/Guide/1.)+Getting+Connected+to+your+Duet/7

Thanks for the link the time it will take is a bit longer than what I am currently experiencing but it isn't too bad 10-12 minutes.The weird thing is the calculator only shows a 4 minute difference between the 300 and 600 w versions of the heater.The 600w is only available in the 110v or 220v versions.The 12v version looks like a better option for me with this printer,I will look into the 110v version and 24v PSU on my Corexy plans.