@phaedrux he has a 2.25mm nozzle don't think going to 1.75mm Filament will work

If i print over Octoprint and change Fan Speed or Extrusion multiplier on Paneldue, Octoprint does not recognize that. How can this be fixed?

Hi all,

Is it possible to show babystepping on PanelDue (5") everytime not only during print?

If i print with a Server like Octoprint the babystepping options are not shown on PanelDue.

Thanks Br Michael

Hi,

I have lot's of disconnects using wifi server version 1.21 (every 2 minutes or so) but no disconnects using Wifi Server 1.20. Wifi Signal strength is quite good at -43dBm

Here are the diagnostics:

Network state is running
WiFi module is connected to access point
Failed messages: pending 0, notready 0, noresp 0
WiFi firmware version 1.20
WiFi MAC address 2c:3a:e8:0b:16:1c
WiFi Vcc 3.41, reset reason Turned on by main processor
WiFi flash size 4194304, free heap 17024
WiFi IP address 10.0.0.104
WiFi signal strength -43dBm, reconnections 0, sleep mode modem
HTTP sessions: 1 of 8
Socket states: 2 0 0 0 0 0 0 0
Responder states: HTTP(1) HTTP(0) HTTP(0) HTTP(0) FTP(0) Telnet(0)

Hi,

I thought i share my experience with PT100 and my Printer setup. I got random 2000 degree spikes throughout the print. It turned out to be noise from the Layer Fan which wires go thru the same cable as the PT100. Reducing the Layer Fan PWM frequency to 10Hz solved the issue and the fan still works very well.