@Terradive said in BTT Smart filament sensor setup:
@jay_s_uk I have also installed a .9 stepper motor on my extruder. I tried doubling the l amounts to compensate but that did not owrk.
When you installed the 0.9 stepper did you also modify your E steps per mm?
@Terradive said in BTT Smart filament sensor setup:
I moved the xstop cable over to the e0 slot and tapped the button a couple of times. The light flickered.
So it sounds like the E0 endstop is responding correctly.
@Terradive said in BTT Smart filament sensor setup:
I'm not real great with multimeters
To test continuity of the cable going between the endstop port and the sensor you would set your multimeter to continuity mode and then touch a probe to an end of the wire at the same time. The meter will usually beep when there is a connection.
Here's an illustrated example of it. https://www.wikihow.com/Test-Continuity-with-a-Multimeter
Can you show a screenshot of the gcode console after sending M591 D0or M591 D1 depending which tool you're using after it has paused?
I don't think there is anything wrong with the Duet itself.
