Hi
Update:
Reheating the pins seems to have doe the trick for now.
Will need to keep a close watch on this, that the issue doesn't reappear.
Thx in advance
T.

@Stephen6309 yes I have

M575 P1 B57600 S1

In config.g - 1st line after setting up wifi.

Small update:

• Z axis work, confirmed was a bad cable connection, easy fix.
• Flashed PanelDue with 1.2.4 and also ran the verify. All is ok. Bossa port appears etc. But still nothing after fully reconnecting it back to the DuetWifi.
• Didn't yet do the upgrade to 3.1.1, avoid multiplying the issues.

So, any advice on how to troubleshoot what's wrong with the PanelDue.
I hear no beepbeep when the DuetWifi boots (or has finished booting), I have 5v in the pinout, and also 3,3 between GND and 3.3V on the Panel Due V2.0 mini board. and also on JP1 (Gnd and 3.3V pin).
Cable between DuetWifi and PanelDue has been checked and confirmed correct and working.

Thx
T.

Hi all,
As you may have noticed, I've restarted my E3D BigBox again.
This has been fully disassembled, cleaned rewired and rebuild.
Now I have some issues (after the SD Card issue)

• Z axis only move in 1 direction, no matter what Direction I push. What may case this,
• Currently running v 1.19.2, do I stay here, or do I move to another version, and if so, what version would that be.
• While troubleshooting, I have pushed the reset button on my 7" PanelDue. How to get that fixed, keep in mind, I'm sure this has a direct impact on the version running.
  Most probably other issues might appear, I'll open another post for those once I get to them.
  Thx in advance
  T.

Hi
Update:
Reheating the pins seems to have doe the trick for now.
Will need to keep a close watch on this, that the issue doesn't reappear.
Thx in advance
T.

Same result.
Might it help if I heat the 3 last pins? (With a good soldering iron)

I'll try later today tomorrow with another sd card
M122 shows there is an sd card
M20 shows an empty list.
Bought here, 2 years ago

Link fixed
SD card works just fine on the PC
Really looks like this : https://duet3d.dozuki.com/Wiki/SD_Card#Section_SD_Card_Socket

Hello,
Just discovered, after relaunching my BigBox3D after quite some time, that I'm having an issue with reading my SD card.
Might it be a bad soldering issue?

What to do?
Regards
Tim

Hi,
More then a month now since this happened.
How much current do you use on your BB, as I just had this issue on 1.19.2 and this at 600mA. Y axis only.
Really strange, started happing since 1st Layer at a nearly 45° angle. And became very agressive after layer 35 (1h in the print).
Have to say, I have been printing the entire day, nothing but small prints. 1st big one since moving from Rumba to DuetWifi.
Greetz
T.

Ditto over here
Just delete them and be amazed