Best posts made by tobias_munich

Hi together,
may i introduce...
Since nearly 6 months I am working on this machine and its still "work in progress"

Build: Hypercube HEVO, Dual Z, 300x300x400
Board: DUET3 + SBC Raspberry Pi4
Firmware: RRF3 Beta 3
Extruder: Zesty Nimble
Z-Sensor: Orion Piezo
X-Min, Y-Min: optical Endstops
DHT22: for chamber temperature

Webcam: RPI-Cam and RPICamControl -> https://elinux.org/RPi-Cam-Web-Interface

Power Control and Monitoring: Sonoff POWR2 with Tasmonta 8.0.1

LEDs: Control WS2812B RGB LEDs with an ESP8266 over WiFi! -> https://github.com/Aircoookie/WLED

Dashboard: Homeassistant

same topic,
I disconnected the SBC for the moment to have a more reliable environment.
hope this will be fixed soon.

i am using the Fisheye Raspicam together with "RPICamcontrol"-Software on the same RPi.
works so far...

if your probe is on the left, shouldn't the X-offset be negative?

@elliott-griffiths it’s frustrating.
After setting it up from scratch.
Means... downloading the current image, and setup a new sd...
still issues.
Stand-alone with SD, no problem.

But the SBC version.
After starting with the new image the sbc connects to the duet. So far so good.
DWC is able to acces the virtual SD with all folders.
But after uploading the config.g to the sys folder and rebooting,
the system has problems to access to the virtual SD with a lot of error messages .
It’s not able to read and access any folder of the virtual SD

It’s so frustrating

I made 2 print with 5 hours print time each, with the SBC connected.

the system is updated to the RC7 and the new DSF Framework, DWC

the system runs stable, no reconnects anymore.

looks good so far for me.

have to test some macros and other topics were i had issues...

thanks to @dc42 , @chrishamm