@j3d,@Phaedrux .M122.txt
Thank you both! you were correct and it solved my problem printer is up and running. Very much appreciate you guys helping me out with this and information that will indeed be useful in the future.

config.g
config.g attached

Hello everyone,
I have an unusual issue when I start my print, I am hoping to find a solution from someone that went through a similar issue or suggest to figure out why.
--Issue:: post code upload; printer heats up and homes all axis. Then I get a message "Print auto-paused due to low voltage"
INFO:
-3d printer-custom, using Duet wifi with the latest firmware update.
-Power supply: I had the MEAN WELL SE-350-24 AC-DC Power Supply when the error came up I figured might be the PS so bought the MEAN WELL SE-450-24 AC-DC Power Supply with no change.
-Verified with a multimeter the output from PS and into Duet board reading at 24.2V
-When sending command M122 printer disconnects and won't load log (figured separate issue)

Please let me know if there is anything i can try to solve my issue and start printing.
Thank you

I am looking for information on connecting PanelDue5i to a Duet 3 6HC. Currently have it on stand-alone configuration. The diagram for the mainboard connections doesn't list the required pinout for the display.
Any suggestions?

Thanks,

I agree it would add additional customization.

It works.
The issue was the copy I initially downloaded, it might have been corrupted. Everything looked good [write, verify] up to the reset point, the board stopped communicating.
Thank you

It shows as Bossa. I am now having an issue where my computer pics up the port but when I write the .bin through Bossa and restart the control board, my computer no longer detects the port. It only picks it up when I erase through the jumper.

Yes, I removed the jumper once the port was detected by Bossa. It successfully writes, verifies, and reads.
After I close the Bossa app and start YAT. See image for the terminal setting, it seems like it is picking up the bossa program port.

I decided to try something new and got a new Duet 3 MB 6H board.
In my attempt to get to know the board I deleted the current firmware per instructions https://duet3d.dozuki.com/Wiki/Getting_Started_With_Duet_3. Now I am not able to connect my board through any user interface.
Instructions I followed;

• Erase current firmware with jumper
• Load/write [Duet3Firmware_MB6HC.bin] through Bossa

I have also tried loading/write; Duet3_SDiap_MB6HC.bin, RepRapFirmware.bin with no success.

I know I am missing something really simple but I been at it with no success. I would appreciate any help getting me started past this point as the rest will be more intuitive.
Thanks,