@phaedrux have managed to get new ip 192.168.1.156. And got machine working, it seems to be retaining ip so far. The files just sent were taken after achieving 192.168.1.156 ip

@phaedrux

@phaedrux will have a look and get back to you

@trev133

@droftarts Thanks Ian for your help, you have probably worked out I am no expert at this. When I put in M587 as suggested I get response as photo attached. I tried M588 to remove remembered network which doesn’t look right. .14 (there are usually 3 numbers.) Removing it doesn’t work, I am sure I am missing something. When I try setting up new ip using M587 I get OK response but never get the new ip address

@phaedrux so I understand, you mean send M587 via Yat software and see what it returns?

@phaedrux I have been using M587 via Yat software and as defined in the process you attached, each time a new ip is assigned and I can run machine but this ip is not being retained when I return in a few days time. Will go through the process again tomorrow and let you know incase I am doing something wrong.

@phaedrux

@phaedrux I have been using the process as attached for manually setting the ip. The duet doesn’t seem to remember it and next time I switch on I have to start the process again. Am I missing a point in the setup where I should be saving the ip?

@phaedrux Thankyou for getting back. My connection is wireless and I have used the same IP address for a few years which was established using the Yat software at initial setup. I assume this is using DHCP. How do I go about defining the reservation as you have suggested. As I said it worked flawlessly for years now I need to use the Yat software to get in and a new IP is allocated each time. Appreciate any help you can give me.