Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. vidguy
    3. Topics
    • Profile
    • Following 0
    • Followers 0
    • Topics 2
    • Posts 5
    • Best 1
    • Controversial 0
    • Groups 0

    Topics created by vidguy

    • vidguyundefined

      TLM not remembering home ,Smart Effector not reaching bed.

      General Discussion
      • • • vidguy
      2
      0
      Votes
      2
      Posts
      105
      Views

      jmjcokeundefined

      M665 L250 R160 B80 H240 X0 Y0 Z0

      Change the H value in config and override by the amount you move the nozzle to reach a slip fit with paper, save config, home, check, save config, change rinse repeat until it will home and go to z0 with slip fit. May have to M564 H0 S0 to reach bed.

    • vidguyundefined

      Short to Ground Error -- Right out of the box

      General Discussion
      • • • vidguy
      5
      0
      Votes
      5
      Posts
      855
      Views

      vidguyundefined

      Thanks for the response.
      I've put the M569 command in my slicer start code and it works fine.

      I've got the printer up and running and all seems to be working.
      I even did a test of a failed power supply: I used the reserect.g as a macro and had the printer resume from where the power cut off pretty much dead on.

      I gotta say, overall surface finish and lack of noise are are big improvement.
      (The loudest parts are the PS and HotEnd fans.)