Posts made by walkwithdeath

Filastruder is sending a new one! Thank you all! Great customer service!

@dc42 Ok, I will. It is an interesting problem.

I have 2 personal 3d printers and I work with 3 professionally for work. So I never seem to get away from them! haha. But glad you got it out, its a very fun hobby!

@Phaedrux Yes, never changes.

Just got my duet 3 board set up with my Tronxy X5SA-500 Pro with dual extrusion by the help from the boards here. Finishing up my test printing and such now but wanted to thank you guys there is loads of information on here!

I bought a Paneldue 7i from Filastruder a couple weeks ago. Did a firmware flash and connected it up the the duet 3 via a 4 pin connector that I swapped the pins around via the official Paneldue wiki page. It worked. Controls worked and connected to the duet 3 just fine. Last night, my Paneldue turned white as I was looking at it. Happned to glance over and it slowly turned from the dark mode to complete white. I disconnected it and tried a firmware flash and reset, nothing, still white. It appears to be working as I randomly clicked on the screen my printer started to do a homing move, but it just stays white. I would have expected this screen to not function or the firmware flash to reset the brightness. I have tried hitting the reset button. Nothing. The Gcode for paneldue is still in my config file. Any suggestions?