New RepRapFirmware config tool

[chrishamm]

@PaulHew said in New RepRapFirmware config tool:

Please could you look at the issue in regards to selecting BLTouch as a probe type for the Ender3 template with RRF3 in the config tool.
It is currently greyed out and is unselect-able.
I mentioned it in a previous post and DC42 informed me he would look into it.
Veti gave me the lines I need for it to work, mapping the pins.
Thanks
Paul

I can select the BLTouch with RRF2 and RRF3 but in order to select it with RRF3, you need to assign the PWM Control Channel on the I/O Mapping page first. Then you can activate BLTouch on the Endstops page.

[PaulHew]

@chrishamm Thanks for the fast reply!
I have a Duet Maestro board.
On the I/O mapping page I cannot select any of the 'PWM Control Channels (BLTouch only).
I can see them in the drop down but they are not selectable.

My thinking was if I was able select BLT on the Endstops page it would automatically create the I/O mapping.

Edit: Also on the Endstops page I cannot select 'Z Probe' for the Z axis

Regards,

Paul.

[chrishamm]

@PaulHew You must set "Z Probe Mod Pin" to (not assigned) before you can use it in the input below. I'll consider that suggestion.

[chrishamm]

@reneh There was a problem in the configtool that prevented the popup from being shown on OS X. It has been fixed in the latest version (2.1.8).

[jay_s_uk]

@chrishamm Is there a github repo for the config tool where issues can be raised to make them easier to track like there is for DWC?

[chrishamm]

@jay_s_uk said in New RepRapFirmware config tool:

@chrishamm Is there a github repo for the config tool where issues can be raised to make them easier to track like there is for DWC?

Yes, it's on GitHub.

[PaulHew]

@chrishamm Again, thanks for the speedy reply.
Ok I have done that and I was able to eventually select Z-Probe and then select BLT. Thank you.

I program, but not what you clever guys write.
As another suggestion for the I/O mapping page, based on selecting the Ender3 template with a Maestro board could there be a tick box for say 'If using a BLTouch check this box'
Which then selects the correct options, using the Ender3 template with a Maestro board makes the changes needed to the I/O mapping page and the Endstop page.?

[reneh]

@Danal

Hi, in google chrome i get such a popup but not in safari. In safari popups not blocked. strange phenomenon. Is there any other safari setting in safari that i need to consider?

Thank you

[infiniteloop]

@reneh said in New RepRapFirmware config tool:

Is there any other safari setting in safari that i need to consider?

Have a look at this guide …

[chrishamm]

Technically it isn't a pop-up, it's just a div. @reneh try to clear your browser cache and it should work again.

[reneh]

Hi all, it works. Thank you very much

Bye