Hello all,

this was very helpful.

Thank you
René

Hello all,

is it possible to connect a duex5 expansion board to an duet maestro board? If not - how can i connect 4 z-stepper motors on a duet maestro board?

Thank you for help.

René

Hi all, it works. Thank you very much

Bye

@Danal

Hi, in google chrome i get such a popup but not in safari. In safari popups not blocked. strange phenomenon. Is there any other safari setting in safari that i need to consider?

Thank you

@chrishamm Hi, great work. I try to use this tool in safari browser 13.04 bud I can not open/edit XYZ Offsets in the too tab. Could you tell me please how can I fix this?

Thank you

Hallo dc42 and Phaedrux,

now it is clear. Thank you very much for your help.

Ahh, thank you very much, I think it was a good explaining. I understood the following: A Z-probe is the measuring device for measuring the bed surface. For a first rough leveling, I can use the wheel screws under my bed (first could and then heated). Then I can use the "True Bed Leveling" function. After that I can use the "Mesh Compensation" function for fine tuning. The firmware saves the measured values ​​during mash compensation. During a printing process, the printer compares the measured values ​​with the values ​​stored in the firmware and compensates the differences by lowering or raising the Z axis. I don't need a Z-Prob for all of these steps. But a Z-Prob replaced the manual steps. Is this correct so far?

Could you tell me, which Z-Prob works good with the duet 2 maestro and is easy to mount and easy to use?

Hello all,

i am a 3d Print newbee and i thought Duet Maestro is a good choose. Bud i am a little confused about some terms. may can help me anyone? My questions are:

1. means Z-Pro Auto bed leveling?
2. What is the difference between „True Bed Levelling“ and „Run Mesh Compensation“?

Thanks al lot, René