Help: Temp Sensors and Homing Issues
-
Here is the result from DWC YAT is not giving me connection options for comm ports. YAT is to difficult
console.txt -
@94118 said in Help: Temp Sensors and Homing Issues:
YAT is to difficult
console.txtM111 S1 P3 has enabled debugging messages to steam to the USB port. You will need either YAT or some other USB terminal to view it.
-
having problems with USB terminal emulators they do not see anything beyond comm 1
-
Does the duet show up as a device in device manager?
-
NO it does not
-
But you are able to connect to the duet via the network and DWC?
-
When you connect the Duet via USB does it make the usb device detected sound?
-
Have you followed this part of the getting connected guide?
Have you installed the drivers?
It also covers YAT.https://duet3d.dozuki.com/Guide/1.)+Getting+Connected+to+your+Duet/7#s5
-
Duet to the network Yes. Duet to USB NO Sound from windows. Unable to install duet drivers cause DM states not compatible with 64bit
-
Request an update for recent message about the paneldue
-
Duet 2 wifi seems to good with USB but not the paneldue
-
Please see the post from DC42 above. https://forum.duet3d.com/post/134957
You need YAT connected via USB so that we can see if there is communication between the paneldue and the duet.
-
Direct from YAT: with Duet 2 plugged in to USB talking to Paneldue
Debugging enabled for modules: GCodes(3)<LF>Debugging disabled for modules: Platform(0) Network(1) Webserver(2) Move(4) Heat(5) DDA(6) Roland(7) Scanner(8) PrintMonitor(9) Storage(10) PortControl(11) DuetExpansion(12) FilamentSensors(13) WiFi(14) Display(15) LinuxInterface(16)<LF>
NO (aux: M408)
What next
-
dc42 said in Help: Temp Sensors and Homing Issues:
If you are using the ribbon cable, make sure it is plugged into the CONN_SD socket on the Duet. Not CONN_LCD.
In your first picture it shows the PanelDue ribbon cable plugged into the wrong port. Are you still connected that way? Have you tried the 4 wire cabling option?
-
disconnected ribbon cable now it shows Idle And Temps
-
So it's working now? Your responses are so short it's hard to know what's actually going on, which makes it very challenging to help you out.
-
I have and got it working by removing the ribbon cable. Now i think its my endstops conflicting with homing controls and commands (https://drive.google.com/open?id=1DxrsV36-5PN991DjbJJKdIKGP0n85crk) picture included status of endstops state Yes
-
If the endstop state says that it' triggered when it's not, then it's likely been defined incorrectly for the switch type.
I don't know what type of switches you have, or how the endstops have been defined in config.g.
https://duet3d.dozuki.com/Wiki/Gcode#Section_M574_Set_endstop_configuration
It's likely a case of needing to change an S0 to S1 or vice versa.
-
Mechanical ENdstops
-
Homing still an issue Please review my config.g File i will Send config.g
