Help: Temp Sensors and Homing Issues

94118

I would use the jog controls for filament load and unload as well as jams or clogging

Phaedrux

The extruder motor won't move unless it's at printing temp.

Are the x and y and z jog buttons working?

94118

they will work only if i press the plus side of the controls then press the negative side

Phaedrux

Ok that probably means that your endstop positions and/or your motor directions aren't correct.

Where is the X endstop? Left or right side?
Where is the Y endstop? Front or back?

94118

X is at the Right, y is at the Left rear corner

Phaedrux

; Endstops
M574 X1 S1 P"!xstop"

That should be

; Endstops
M574 X2 S1 P"!xstop"

Because your X endstop is at the high end of travel on the right side.

Change that and see if it works better after homing.

94118

when i changed it from x1 to x2 motor direction went in opposite direction so i changed it back to x1

94118

Should i change my "Z" endstop from x2 to x1 cause current tool postition read (x230, y210, z0) i think it should be 200 or 195

94118

Failed to load filaments
Directory 0:/filaments not found

i was trying to setup a filaments list for PLA, ABS, PetG

Phaedrux

when i changed it from x1 to x2 motor direction went in opposite direction so i changed it back to x1

Leave it as X2, and change the direction of the X motor as well. You have S1, should be S0.

; Drives
M569 P0 S0                                     ; physical drive 0 goes forwards

Should i change my "Z" endstop from x2 to x1 cause current tool postition read (x230, y210, z0) i think it should be 200 or 195

No, When the nozzle is at the bed, it's at 0. When the bed or nozzle move away from each other, the Z axis increases position.

Failed to load filaments
Directory 0:/filaments not found

i was trying to setup a filaments list for PLA, ABS, PetG

Put the SD card in your PC and create the filaments folder manually.

94118

the Sd card from the duet 2 wifi board cause i do not have one for the panel

Phaedrux

the Sd card from the duet 2 wifi board

yes.

94118

recommended steps per mm for PetG as that is currently the roll of filament i have on the printer

Phaedrux

Is that a question?

94118

Yes that is the question!

Phaedrux

You'll need to calibrate the extruder.

Do you have a known starting value for the extruder typical for that printer/extruder?

94118

Example shows an ender 3 i do not own an ender 3

Danal

Calibrating the extruder is the same process on every printer.

94118

have calibrated my extruder here are my numbers.

they all seem inconsistent to me

Phaedrux

Well it seems to be bouncing around a central value. Try starting with the average. 314.

You may need to do it several more times if your starting value wasn't very close to being correct.