duet firmware m997 s0

[Phaedrux]

Yes it needs to be extracted into /www

[MRJEON]

@Phaedrux
m122 wifi section...

• WiFi -
  Network state is active
  WiFi module is idle
  Failed messages: pending 0, notready 0, noresp 0
  WiFi firmware version 1.23
  WiFi MAC address ec:fa:bc:5b:45:b7
  WiFi Vcc 3.36, reset reason Unknown
  WiFi flash size 4194304, free heap 30176
  Socket states: 0 0 0 0 0 0 0 0
  ok

and

m587 command..

m587
Remembered networks:
TNCAPF318D9 IP=192.168.1.24 GW=0.0.0.0 NM=0.0.0.0
clane IP=0.0.0.0 GW=0.0.0.0 NM=0.0.0.0
clane printer IP=0.0.0.0 GW=0.0.0.0 NM=0.0.0.0
ok

If you enter 192.168.1.24 in the address bar, doesn't the web control window appear?

[dc42]

@MRJEON said in duet firmware m997 s0:

WiFi module is idle

That's why you can't connect. What happens if you send M552 S1 from USB? You should get a response within 30 seconds.

[MRJEON]

@dc42
m552 s1
ok
WiFi reported error: no known networks found
WiFi module is idle

....

[dc42]

So it can't find your router. Try deleting the stored networks using M588 S"*", then use M587 to enter the router SSID and password again. Note, the SSID and password are case sensitive.

[MRJEON]

@dc42 said in duet firmware m997 s0:

So it can't find your router. Try deleting the stored networks using M588 S"*", then use M587 to enter the router SSID and password again. Note, the SSID and password are case sensitive.

m588 s"*"
ok
m587 s"test" p"dkdlarkt1@"
ok
m587 s"test" p"wifi1234"
ok
m587
Remembered networks:
test IP=0.0.0.0 GW=0.0.0.0 NM=0.0.0.0
ok
m552 s1
ok
WiFi reported error: no known networks found
WiFi module is idle

[MRJEON]

@MRJEON so sad... what's wrong..

[dc42]

Do you actually have a router whose SSID is "test" ?

[MRJEON]

@dc42 sorry I couldn't input the correct ssid and pw. Does duet 2 wifi support 5G?

[dc42]

You need to enter the correct SSID and password for your WiFi router.

[MRJEON]

@dc42

this password...??what...???

[jay_s_uk]

@MRJEON said in duet firmware m997 s0:

M551 P"CLANE" ; set password

I guess it's CLANE???

[MRJEON]

@jay_s_uk ok thanks!!