Problem with rear side of Test Cube
-
From what I have read ABS really needs a heated enclosure BUT I don't know if that is related to your problem.
Frederick
-
@alankilian said in Problem with rear side of Test Cube:
1/ Do you see filament extruding on the back cornets?
2/ Do you hear your extruder struggling/clicking when that happens?
3/ Can you rotate the cube 180-degrees to see if it then happens on the front?
4/Can you rotate the entire printer 180-degrees to see if it changes due to airflow?
5/Do you have an enclosure?1/ Back cornets?
2/No clicking, extruding nicely when I move it up and extrude some filament.
3/I should have mentioned that I had done that, it still happens on the rear (mainly)
4/The pinter is on a wheeled trolley, I have tried that. Ambient temp is 18.4C atm. -
"From what I have read ABS really needs a heated enclosure BUT I don't know if that is related to your problem. Frederick"
Yes, I found that out a while ago, which is why I made the one in the pic. It is made from 50mm expanded foam, coated with thin fiberglass panels. The material came from an old coolroom.
-
But the issue remains. Any other helpful suggestions, they've been good so far?
-
@dmbgo said in Problem with rear side of Test Cube:
But the issue remains. Any other helpful suggestions, they've been good so far?
Instead of printing a cube can you create a model of a disc, say, 50 mm in diameter and 5 mm thick?
If you can print it using you normal settings.
Frederick
-
-
Sorry Fredrick, but my modelling capability is V low. Could you please suggest a model from thingiverse or somewhere?
-
@dmbgo said in Problem with rear side of Test Cube:
Sorry Fredrick, but my modelling capability is V low. Could you please suggest a model from thingiverse or somewhere?
Here you go.
Slice it normally but keep the layer cooling fan(s) off.
Frederick
-
Thanks Fredrick
-
-
@dmbgo said in Problem with rear side of Test Cube:
Printing now
I will check back in a bit.
Frederick
-
Where are you Fredrick? If it is too late at night, we can leave it until tomorrow.
-
@dmbgo I'm here.
Frederick
-
The disk is printing at 30 mm/s. It will probably take about 20mins more.
-
@dmbgo said in Problem with rear side of Test Cube:
The disk is printing at 30 mm/s. It will probably take about 20mins more.
What does it look like so far?
Frederick
-
-
OK.
I'll check back in 15 mins.
Frederick
-
The bed levelling is a bit out now, but I dont think it will affect the disc
-
-