Changing fan out from out9 to out5 has no effect
-
that is why i asked for a picture so i can be sure that his wiring is incorrect
-
@alankilian said in Changing fan out from out9 to out5 has no effect:
your fan going to (BLACK)-> OUT5 and (RED) to V_OUTLC1
Try this and see if it works for you.
-
@alankilian Still running at 100% cant controll it from webcontroll.
-
And i cant run it from Out7-9 since fans in Out8-9 are 24v.
-
@Veti it is correct...
-
Got it to work, now the broblem is that the fans stop spinning at 70% in webcontroll, full blast at 100% and about 50% speed when set to 94% in webcontroll.
-
@Snippy said in Changing fan out from out9 to out5 has no effect:
Got it to work,
so what was wrong?
the fans stop spinning at 70% in webcontroll, full blast at 100% and about 50%
try adjusting the frequency q.
try 10 , 50, 5000 25000
-
@Veti no idea, did the old ''have you tried turning it on and off again'' for about 5 times and told the printer i will build a new one so i think the tea and bisquits chip in the duet started to listen.
-
yes 10 was good,
Now all i need to do is design and simulate the cooling pipes. -
Thanks for the help.
-
@Snippy said in Changing fan out from out9 to out5 has no effect:
Thanks for the help.
I'm glad you got it worked out.
-
These duet boards are great if you dont haveto touch the settings, it seems to allways open a can of worms that requires a sacrifice or two to appease the great one.
