No WiFi this morning !?

[tecno]

Anyone to help me?

[jay_s_uk]

@tecno sounds like you lost your config.g again?

[tecno]

@jay_s_uk

Maybe, how do I get the board to respond?

[jay_s_uk]

@tecno well i suggest following this https://duet3d.dozuki.com/Wiki/What_to_do_if_your_Duet_won't_respond#Section_Check_the_voltage_indication_LEDs

check your sd card to see if config.g is there and what its contents is

[tecno]

@jay_s_uk

LED's are lit
config.g is there and all looks familiar

[jay_s_uk]

@tecno send these over USB

M552 S0
M552 S1

let us know what the output is

[tecno]

@jay_s_uk

As I wrote earlier this morning:

In red, terminal response to what ever command is sent

Warning : x bytes not sent anymore

[jay_s_uk]

@tecno no idea then. never seen that warning, especially not in red. all terminal programs I use are black and white

[tecno]

@jay_s_uk

YAT

But.... now the bloody bord is working with another IP

How do I set fixed IP ??

[jay_s_uk]

@tecno using M587 https://duet3d.dozuki.com/Wiki/Gcode#Section_M587_Add_WiFi_host_network_to_remembered_list_or_list_remembered_networks
or the better way is to reserve the IP at the router side

[tecno]

@jay_s_uk

Thanks Jay!
Went M587 way as my router is not so friendly

[droftarts]

@tecno Did both config.g and config.g.bak disappear, or did you have a config.g that was blank? Did you edit config.g before last reset/power off? See my reply here https://forum.duet3d.com/post/233267

Ian

[tecno]

@droftarts

Today everything was on the card, it just didn´t boot. So card out to see what was there and back was all it took to start working with another IP

[droftarts]

@tecno Have you replaced the SD card? And can you have a close look at the SD card socket, see https://duet3d.dozuki.com/Wiki/SD_Card#Section_SD_Card_Socket

Ian

[tecno]

@droftarts

No
Will take a look next time I dig out the printer from its cabinette.

[Phaedrux]

@phaedrux said in No WiFi this morning !?:

@tecno said in No WiFi this morning !?:

WiFi firmware version 1.24beta2-05b1

Your wifi server version needs to be updated.

Place this bin file in your firmware folder and then boot up and send M997 S1 to re-flash the wifi module.

https://github.com/Duet3D/RepRapFirmware/releases/download/3.3RC3/DuetWiFiServer.bin

Then check M122 again it should show the wifi server version as 1.26.

Were you able to update the wifi server?

[tecno]

@phaedrux