please help me blv setting

jay_s_uk

@sgk said in please help me blv setting:

M563 P0 S"T0" D0 H1 F1

the fan defined here should be F0 not F1

nothing else looks out of place.
which bits do you have issues with?
and which firmware version are you running? M115 will tell you

A Former User

@jay_s_uk Board: Duet 2 WiFi (2WiFi)
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.3 (2021-06-15)
Duet WiFi Server Version: 1.26

A Former User

@jay_s_uk said in please help me blv setting:

which bits do you have issues with?I do not understand

jay_s_uk

@sgk what problems are you having?

A Former User

@jay_s_uk when I print my pieces where the cubes are of a really bad quality even with my cr10 which is not in good condition I have better impression. I have changed a lot of things on my blv and always a shit quality excused me word

jay_s_uk

@sgk well make the change i suggested here and then print another cube and see how that comes out
https://forum.duet3d.com/topic/26387/please-help-me-blv-setting/11

A Former User

@jay_s_uk ok thank you sir jay

A Former User

@sgk

A Former User

@sgk
it’s the same if it’s not worse

oliof

Looks like you need to to flow and temperature calibration. Here is a website which may help you with that https://teachingtechyt.github.io/calibration.html

A Former User

@oliof
I have done plenty of times

oliof

@sgk you have massive deformation at the bottom of the cube which looks like the heated bed is way too hot, and the extrusion looks very uneven but not spotty/spidery, except for the stringing. Maybe share the gcode file with us (you can upload it) so we can take a look.

A Former User

@oliof
the deformation is the fan

A Former User

@sgk xyzCalibration_cube.gcode

engikeneer

@sgk what material is it that you are printing?

Looking at your gcode file you have set the bed to 90C. That is waaaaay too hot for PLA and I doubt your extruder temp of 195C would be correct if it was PETG or ABS.

Leads me to think that @oliof was right and the deformation at the bottom of the part is because it is too hot and the part is melting!

TYPE:Custom
M104 S195; set extruder temp
M140 S90 ; set bed temp
M109 S195 ; wait for extruder temp
M190 S90 ; wait for bed temp

A Former User

but if I have but not 90 it does not adhere to the bed.
pla

A Former User

@engikeneer
and as we see in the photo it is already peeling off on the corner

A Former User

@engikeneer I've been fighting for months, I've changed a lot of things but still the same I'm at the end of the line

oliof

@sgk what is your print surface?

A Former User

@oliof 350x350mm