M584 help needed

[fcwilt]

@jlee73 said in M584 help needed:

@phaedrux I meant x moves when I try to move y sorry

Did you experiment with the X and Y values in M669?

Frederick

[jlee73]

@phaedrux After doing some more reading I think I’ve got it set up wrong on the M669 code. It should be M669K0. Will try that tomorrow

[Phaedrux]

Knnn Kinematics type: 0 = Cartesian, 1 = CoreXY,

So it's cartesian, and not corexy?

[jlee73]

@phaedrux it has to be. K1 would most likely tell the motors on x&y to move at the same time right? But a K0 would allow the x&y motors to move independently correct?

[Phaedrux]

What does the belt path for the printer look like? Can you show a photo?

This is what a corexy belt setup looks like.

simple_belts_corexy_annotated.jpg

[jlee73]

@phaedrux Yeah that’s not it at all

[jlee73]

This post is deleted!

[Phaedrux]

That is cartesian.

[jlee73]

@phaedrux tomorrow when I get back there I will change it to you M669K0

[jlee73]

@phaedrux That was the entire problem I just got back to the office changed it to him 669K0 and it completely solve the problem thanks for everyone’s help