@phaedrux That was the entire problem I just got back to the office changed it to him 669K0 and it completely solve the problem thanks for everyone’s help

@phaedrux That was the entire problem I just got back to the office changed it to him 669K0 and it completely solve the problem thanks for everyone’s help

@phaedrux tomorrow when I get back there I will change it to you M669K0

@phaedrux Yeah that’s not it at all

@phaedrux it has to be. K1 would most likely tell the motors on x&y to move at the same time right? But a K0 would allow the x&y motors to move independently correct?

@phaedrux After doing some more reading I think I’ve got it set up wrong on the M669 code. It should be M669K0. Will try that tomorrow

@phaedrux I will have to get that to you tomorrow

@phaedrux I meant x moves when I try to move y sorry

@phaedrux I tried the forum won’t let me upload it because it’s too big

@jlee73 it has nothing to do w Z

@phaedrux

No, once everything is homed on dwc, i then try ti use the move "y" by 1,10 or 50 buttons to move the y which is my hotend. when i do that the x axis also moves it should not move at all.