Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Tags
    3. failure
    Log in to post
    • All categories
    • mballinundefined

      Solved Print Cancelled and then printer Halted while printing

      General Discussion
      • halt failure software reset • • mballin
      8
      0
      Votes
      8
      Posts
      172
      Views

      mballinundefined

      @mballin Ended up being the emergency stop switch, after removing was able to print with no problem! Thanks for the help!

    • wurth51undefined

      Solved Thermister problems: Duet Wifi Board v1.0

      Duet Hardware and wiring
      • duet wifi thermistor broken failure heating fault • • wurth51
      16
      0
      Votes
      16
      Posts
      1.1k
      Views

      dc42undefined

      @wurth51 if you get a short between Vssa and a higher voltage then you should get a message on the DWC console warning you of the short.

    • duet3questionmasterundefined

      Selfmade Gear Rack Gripper Making Problems

      My Duet controlled machine
      • toolboad gripper driver failure • • duet3questionmaster
      3
      0
      Votes
      3
      Posts
      339
      Views

      fcwiltundefined

      @duet3questionmaster

      Perhaps you could post some pictures of the device?

      Frederick

    • callielliundefined

      Burnt Y-Axis Motor on brand new board?

      Duet Hardware and wiring
      • burnt driver failure • • callielli
      4
      0
      Votes
      4
      Posts
      360
      Views

      callielliundefined

      @dc42 said in Burnt Y-Axis Motor on brand new board?:

      It sounds like an infant mortality failure of the driver chip. Assuming it's a genuine Duet, your board will be replaced under warranty. Please contact your supplier.

      Thanks for the prompt response. I imagine this is a rare fault?

      I will head over to the original supplier tomorrow and complete the warranty.

    • blimpmobileundefined

      Tilt senor for emergency stop?

      Duet Hardware and wiring
      • tilt sensor stop emergency detect failure • • blimpmobile
      5
      0
      Votes
      5
      Posts
      688
      Views

      mrehorstdmdundefined

      I used to use a steel ball on the frame to level my old printer when it was set up at a new location- it was much more sensitive to tilt than a bubble level. If the X axis uses a piece of t-slot you can put a steel ball on it and it will be a very sensitive tilt sensor. Then all you have to do is detect the ball, either optically, magnetically, or using a piezo element.

      In a dual motor set-up the X axis won't usually tilt while the machine is printing, so the Prusa technique of running the X axis to the top of the Z axis and a little beyond to force the Z motors/screws to sync works pretty well.