@gerrard
It looks better, let's hope the print doesn't shrink too much this time 😉

I saw a simple way to improve your printer: the tall idler bearings should be supported from both ends.
idlers.jpg

@arhi
Solidworks has too much marketshare for a major company to use much else... cross platform work becomes a major problem very quickly.

That said, paid Fusion360 is very good value for people doing less complicated stuff.

But they always told their partners that the free versions would only continue until they had hit a big enough user base.
If they haven't already, expect the free 12 months deals to start drying up.

Plus their senior execs are much less maker focused than in the past.

Hi,

The only thing that exists in the slicer related to starting/ending a print are calls to macros

print_begin.g print_end.g ; ----- print_begin.g ----- ; ; must occur after... ; - all axes have been homed M106 P2 S255 ; lights on M106 P6 S255 ; lights on M106 P7 S255 ; lights on G90 ; absolute moves G1 Z75 F1200 ; position for cleaning G1 X0 Y-145 F6000 ; position for cleaning T0 ; select tool 0 so extruder commands below will work M703 ; configure selected filament (sets temp set points) M291 R"Waiting on heaters to reach set points..." T0 M116 ; wait for temps to reach set points M291 R"Priming extruder..." T0 G92 E0 ; reset the extruder logical position M83 ; extruder relative mode G1 E10 F120 ; prime the extruder G92 E0 ; reset the extruder logical position M400 ; wait for extruding to finish M291 R"Clean Nozzle and Bed" P"Click OK when ready to print" S3 M98 P"configprobe.g" ; configure Z probe M98 P"probeZ.g" ; set Z=0 datum G29 S1 ; load height map M291 R"Starting to print..." T1