Ender 5 Plus with dual z calibration
-
Wouldnt moving the connector at the board take the wiring out of the equation? I'm thinking that the y driver might be bad. Because the same motor and wiring on the x driver worked as intended.
-
ah i get you. you did swap the wire that way as well.
so if you move reconfigure the driver to be on the duex it works for both?
-
I dont know how to reconfigure the y driver to be on the duex
-
Changed what it think it would to drive 6 and still get the stuttering
-
Tried reloading firmware, new configuration from the config tool nothing has worked
-
@nightmare90gt said in Ender 5 Plus with dual z calibration:
M584 X0 Y1 Z2:5 E3:4 ; configure 2 Z motors connected to outputs Z and P5
change to
M584 X0 Y6 Z2:5 E3:4 ; configure 2 Z motors connected to outputs Z and P5 -
I did that still did the samething
-
with the motors powered can you move the belt of the x or y motors without much force?
-
@Veti with the printer on I can move the belts without much force. I have even tried this with a spare motor that way belts dont come into play
-
Seems to only do it when x and y are asked to work together
-
maybe the movement wasnt 45 degrees.
after homing. issue
G0 X0 Y0
then
G0 X100 Y100
that should be a movement where only one motor moves.
with the printer on I can move the belts without much force.
not printer on. motors powered. test this directly after a move.
-
Top belt needs a lot of force. Bottom very little
-
Y motor runs the top belt, x motor runs the bottom belt
-
measure the resistance of each phases on the cable connecting to the duet.
-
@Veti to both motors or just the motor having the problem. With power to the motors?
-
unplug the motor from the duet (with the duet off).
measure the resistance of each phase of both motors at the plug.
they should all be the same. -
2.2 ohms on both motors and each coil
-
do you know the specs of the motor?
i found a 2.2 ohm motor and that one is 1.7 A, which would mean you are running way to little current.
-
Kay3d told me 1.5a so I went to 1200ma and the stuttering got worse backed it down until the stuttering has appeared to stop at 1050ma
-
But still get a little stuttering but not nearly as bad
