Solved Tool missing after update to firmware 3.3
I was about to post another totally unrelated problem I am experiencing, but I decided to update the firmware to the latest stable release just to try it out and see if the issue got resolved by itself... and then I run into the problem stated on the thread title.
After upgrading to Firmware Version 3.3, the hotend tool on the web interface just vanished and if I run the macro I have to set the hotend temperature, it doesn't work. On the Paneldue display I can see a temperature displayed, but if I try to set a temperature, it tells me "Tool 0 not found".
I am on a Duet WiFi 2, by the way. Here is the relevant section of the config.g file:
Any help will be appreciated. I haven't used my machines for quite some time and I am significantly rusty...
; Bed Heaters/Thermistors M308 S0 P"bedtemp" Y"thermistor" T100000 B4092 C0 R4700 ; Define thermistor M950 H0 C"bedheat" T0 ; Link pin name with heater M307 H0 B0 S1.00 ; Disable bang-bang mode for the bed heater and set PWM limit M140 H0 ; Links everything on the GUI M143 H0 S95 ; Set temperature limit for heater 0 to 95C ; HotEnd Heaters/Thermistors M308 S1 P"e0temp" Y"thermistor" T100000 B4725 C7.06e-8 R4725 ; Define thermistor M950 H1 C"e0heat" T1 ; Link pin name with heater M143 H1 S290 ; Set temperature limit for heater 1 to 290C ; Bed / HotEnd Autotunes M307 H1 R2.212 C274.1 D8.07 S1.00 V24.2 ; Hotend Autotune //Changed M307 H0 R0.729 C235.0 D3.27 S1.00 ; Bed Autotune //Changed. Silicone heated bed. ; Fans M950 F0 C"fan0" Q500 M106 P0 S0 H-1 ; Set fan 0 value, PWM signal inversion and frequency. Thermostatic control is turned off M950 F1 C"fan1" Q500 M106 P1 S0.85 H1 T45 ; Set fan 1 value, PWM signal inversion and frequency. Thermostatic control is turned on ; Tools M563 P0 D0 H1 ; Define tool 0 G10 P0 X0 Y0 Z0 ; Set tool 0 axis offsets G10 P0 R0 S0 ; Set initial tool 0 active and standby temperatures to 0C
JoergS5 last edited by JoergS5
@felixh maybe you need T0 at the end of the config, document says "After a reset tools will not start heating until they are selected. ".
jay_s_uk last edited by
@felixh have you got the driver for the extruder mapped in M584?
In the notes from 3.3 release
All extruders must be declared explicitly using M584. In previous firmware versions, one default extruder was assign to driver 3.
@phaedrux ... I guess I should start reading the release notes from now on... thanks!