sensor ir
-
-
@sgk
Where is the M558 command located?
In your config.g file?
If so please execute, from the DWC Console, M98 P"config.g" and see if any errors are reported.
Frederick
-
@jumpedwithbothfeet yes look
-
-
@sgk
Thank you.
It seems that the IR sensor is working based on the LEDs on it responding to the presence of the bed.
The M558 configuration seems to be correct and if it is in your config.g file it appears to be executing without any problems.
So that really seems to leave only the connection from the IR Sensor output to the Duet Z Probe input.
Do you have a meter of any sort that can verify continuity of the wire from the connector for the IR Sensor all the way to the connector for the Duet Z Probe input?
Frederick
-
@fcwilt yes I tested with a multimeter the continuity
-
@sgk said in sensor ir:
@fcwilt yes I tested with a multimeter the continuity
OK can you do this:
- Disconnect the connector from the IR Sensor
- Using a small piece of wire or equivalent connect the signal and ground pins of that connector and check the DWC Z probe reading
- Then do the same but connecting the signal and power pins
Frederick
Printers: A FT-5 with the 713 upgrade bits, a custom MarkForged style, a small Utilmaker style, a small CoreXY from kit and a E3D MS/TC setup. Various hotends. Using Duets (2 and 3) running 3.4.6
-
@sgk I just looked at your config.g what firmware version are you using version 1? it might be an idea to update it!
6HC Voron Trident based, 6XD CNC, Mini 5 polar printer
-
@fcwilt
you can tell me what they are -
-
-
@fcwilt sorry which thread
-
-
@fcwilt sorry my translator is kidding
-
@sgk said in sensor ir:
@fcwilt sorry my translator is kidding
OK I will post again my question again:
OK can you do this:
- Disconnect the connector from the IR Sensor
- Using a small piece of wire or equivalent connect the signal and ground pins of that connector and check the DWC Z probe reading
- Then do the same but connecting the signal and power pinsFrederick
-
the probe works but when I do g30 s-1 the bed stays at a great distance from the nozzle as in the photo
-
-
@sgk
If you move the bed away from the probe, say to Z=5, does then doing a G30 or a G30 S-1 result in the bed moving and triggering the probe?
Frederick
Printers: A FT-5 with the 713 upgrade bits, a custom MarkForged style, a small Utilmaker style, a small CoreXY from kit and a E3D MS/TC setup. Various hotends. Using Duets (2 and 3) running 3.4.6
-
@fcwilt yes
-
