New XZmotors problem
-
@aceranic I had to change direction as I was getting Phase warnings....
Also I have 2 motors on Y axis, connected to 2 Z axis drivers. -
@aceranic it could be a result of the fairly low jerk (M556) settings you have.
Your acceleration settings are also very low (M201) -
@jay_s_uk Ok, I didnt have such issue before with same settings. They are set higher is slicer.
-
Increased current and accwl, jerk, still the same.
-
Incresed all values but still no luck
-
@aceranic i guess its mechanical issue
-
@jay_s_uk Not sure still. After board restart it was moving fine few times full X travel. Then I started the print and same issue again.
I tried one older print large size, same. -
Are you using mesh compensation? Can you try disabling it if you are?
-
@Phaedrux Hi. Will try. Only thing I didnt try yet.
-
Yep. It seems that 25mm grid was too much to chew. Thanks!!!!
By the way Phaedrux, I ordered BTT extension for 3 drivers for my MMU. Will need help with that
