Does it get worst when u print @ 0.1mm layer hight? (does the "ringing" changes, increase?)

Do you have quality 3M belts or china? How about your hotend mount is it stable or wobbly.

U mean M203? there is no Z parameter for M204... The Z parameter is from your config u posted before I would set it to Z680 or 720 depends on your Z axis setup, weight of the heatbed ect... Using pressure advance u schould set your jerk min. to 600 so mayby try to turn off pressure advance too.

Hi,

try:

M201 X1000 Y1000 Z250 E600
M203 X12000 Y12000 Z1800 E3600
M204 P1500 T2500

and try to print a test cube @ 30mm/s max. 40mm/s, show some pictures.

Greetings

My jerk settings all time for z-axis was 24mm/min so 0.4mm/sec i have a feeling comparing my other prints to the actual that the print quality in z-axis decreased….

Hi,

I'm not able to set my jerk for Z below a value of "60", everything above is accepted using the M566 Z… command over console or config.g. I dont have any config-overdrive.g file. Any help appreciated. Firmware is 1.21 but same happens on 1.21RCX firmware.

Hello,

Is it possible to use 2 standalone IR hight sensors for an IDEX machine on each x-carriage , to be able to calibrate each hotend, if yes then how to connect them to the duetwifi… as there is only one z probe connector or is there another alternative?

Mayby Tony can test it

Yea maybe there is a small fix for it? just to make it clean there is nothing else connected to the duetwifi just:

• external power 24V
• paneldue

thats all

Ok i found something if i touch with 1 finger the back of the PCB from the display in the middle the issue is gone display just works perfect if i take the finger off its there again! or if use just a small line of tape…