Posts made by Neoxio

Does it get worst when u print @ 0.1mm layer hight? (does the "ringing" changes, increase?)

Do you have quality 3M belts or china? How about your hotend mount is it stable or wobbly.

U mean M203? there is no Z parameter for M204... The Z parameter is from your config u posted before I would set it to Z680 or 720 depends on your Z axis setup, weight of the heatbed ect... Using pressure advance u schould set your jerk min. to 600 so mayby try to turn off pressure advance too.

Hi,

try:

M201 X1000 Y1000 Z250 E600
M203 X12000 Y12000 Z1800 E3600
M204 P1500 T2500

and try to print a test cube @ 30mm/s max. 40mm/s, show some pictures.

Greetings

My jerk settings all time for z-axis was 24mm/min so 0.4mm/sec i have a feeling comparing my other prints to the actual that the print quality in z-axis decreased….

Hi,

I'm not able to set my jerk for Z below a value of "60", everything above is accepted using the M566 Z… command over console or config.g. I dont have any config-overdrive.g file. Any help appreciated. Firmware is 1.21 but same happens on 1.21RCX firmware.

Hello,

Is it possible to use 2 standalone IR hight sensors for an IDEX machine on each x-carriage , to be able to calibrate each hotend, if yes then how to connect them to the duetwifi… as there is only one z probe connector or is there another alternative?

Mayby Tony can test it

Yea maybe there is a small fix for it? just to make it clean there is nothing else connected to the duetwifi just:

• external power 24V
• paneldue

thats all

Ok i found something if i touch with 1 finger the back of the PCB from the display in the middle the issue is gone display just works perfect if i take the finger off its there again! or if use just a small line of tape…

Hi Tony,

i just send u the details for this order.

Thank you for the fast help guys.

Well,

mine does more like flickering/tearing over the whole image displayed its impossible not to seen this just in case i did check different external power sources connected to duetwifi 12V, 24V or standalone 5V over PC USB its always the same issue, left it on for 1-2h then off for 5h and then powering again same problem its like nothing helps at all. Its does look like there is some noise that interfering the displayed image.

Hmm its been bought over on www.duet3d.com isent this forum a propper place to ask? besides its very strange not to check the electronics before selling it and sending over to a customer.

Hi to all

first of excuse for mine bad English…

I received today mine duetwifi along with paneldue 7 inch and i have some strange problem with the display, below there is a link to a video showing the issue (u can see some distortions on the whole displaying image like it would "swim" everything is wired according to wiki page and the duetwifi is powered over external 24V power supply). I managed to update the paneldue 7 inch firmware with success but the issue is still there. Please advice. Thanks.

link to video with issue: https://www.dropbox.com/s/ese8xpaq2f074xs/VID_20161214_191951.mp4?dl=0