Topics created by AlecSanchez

@AlecSanchez I agree with @jay_s_uk, that's way too many TfrRdy glitches and too many checksum errors. You should check the ribbon cable and make sure there is no source of interference next to it (power cables for example). If there is none, consider replacing the cable or put some shield wrap around it and check if that improves things.

@dc42 I completely agree. Some guides point towards very high tension on belts, but at those tensions you run high risk of bending motor shafts or breaking idler bearings ....

@infiniteloop @Phaedrux Just a follow-up regarding this issue. The 3.3v pin on the duet connector has been working great, but with two small nuances:

The bltouch red light is constantly blinking as if its in alarm mode, although it functions as normal

the bltouch does not retract when triggered anymore. I had to add an m402 command in all moves that require probing. It is nice when it is doing a mesh bed leveling though as it is not constantly deploying and retracting

@rushmere3d Ah I see it was wired to v_in + gnd thats why it was always on with no control. Thank you so much! They are working fine now