Topics created by andyvirus

Yep that works. Tested in my tfree0 and 1 and works as i expected. At end of a tool usage it waits for the active tool to cool a bit so stops oozing out my volcano, wipes and switches tool. This will prevent alot of random oozed filament from being dragged about and falling off randomly.

THanks!

You can configure a maximum amount of individual leadscrew adjustment to apply in the M671 S parameter, to avoid binding. No adjustment will be performed if the adjustment to any leadscrew would exceed that limit.

You can test how well it would work before you buy a DueX by using the manual bed levelling assistant, which uses the same code. See https://duet3d.com/wiki/Using_the_manual_bed_levelling_assistant.

Ok, removing the G1 Z-999 S1 has resolved it. Thanks!

Andy - It was how I was doing it, but as I wrote earlier the issue is that the tool change scripts are executed and then the next movement command for the new tool, which inevitably is some distance away.

What I ended up doing was used "Z hop" in the slicer (0.2mm worked fine for me) which raised the ehozzle by just enough to clear everything whenever there is a travel move, and also happens on a tool change.

Edited to add that all movement in a G1 command is executed to synchronise over the move. If you want XY, then Z, use two G1 commands.

Thanks! Thats exactly what I was looking for. Look forward to the next release to give this a try.

Thanks Again!

Ah S2 is what i was missing from T3P3Tony's macros. Added it and all seems well now. Thanks to both!