Best posts made by bast

@droftarts said in Accelerometer on toolboard 1.3 : positioning:

I have updated the documentation page using images from the pdf kindly supplied by @Nuramori. Unfortunately I can't upload pdfs to the wiki software, so I have left the original link in.

https://docs.duet3d.com/en/User_manual/Connecting_hardware/Sensors_Accelerometer#orientation

Ian

nice documentation update for orientation toolboard !
thanks a lot @droftarts !
little pics of my config on a RR-Vcore 500 on duet 5+mini with toolboard (Ir sensor on toolboard)

@Phaedrux
thanks it' solved with manualy update firware (copy past firmware on sd card )

I tested all the boards independently
I have toolboard 0 (adress20) which creates a conflict for me in the general can bus
I am reconfiguring a toolboard to replace it
thank you

OK you awsome
My M140 H0 was after M143 so now it would be good

M143 H0
Heater 0 monitor 0 uses sensor 0 to generate a heater fault if the reading exceeds 180.0°C
Heater 0 monitor 1 is disabled
Heater 0 monitor 2 is disabled

thanks a lot guys