Best posts made by Eman74

@Phaedrux I just tried but it prevents me from posting new topics... it seems the same issue there was this morning...

@fcwilt said in Endstops triggered without anything connected:

M98 P"config.g"

M98 P"config.g"

HTTP is enabled on port 80
FTP is disabled
TELNET is disabled

this is what I get, anyway I'll soon update to RRF3, my understanding is it's way more powerful and has more development potential

@Phaedrux sure it's a duet wifi with a duex5 I'm going to start a thread thank you

I'm in the middle of a BLTouch nightmare... and I keep banging my head over it...

My BLTouch is original latest version 3.1

I updated to RRF 3 (lost a lot of time to get all axis and endstop working but all seems good a part from the BLTouch)

here is my config.g related (deployprobe and retracct are standard..):

M574 Z1 S2                                     ; configure Z-probe endstop for low end on Z
M558 P9 C"^zprobe.in" H5 F100 T3000            ; BLTouch connected to Z probe IN pin, free up MOD pin
M950 S0 C"exp.heater7"                         ; servo/gpio 0 is Z probe MOD pin tried also duex.pwm5 and !exp.heater7 without success
M280 P0 S10                                    ; send control signal to BLTouch through servo/gpio 0
G31 P25 X28 Y-61 Z0    		                   ; BLTouch set offset
M557 X50:350 Y50:350 S50                       ; define mesh grid

My Troubleshooting:

1. Double-checked wiring and tested connectivity with a tester;
2. verified jumper presence on duex 5
3. verified led on heater7 is switched on when I start the system
4. replaced BLTouch with another perfectly working on my cartesian printer with duet wifi and the behaviour is the same erroneous one, it does lights on and blink red without passing the switch-on test
5. tried other heaters on the duex with same result...

NOTE: I have 3 Z motors configured and working on Drive 5:6:7 (M584 X0 Y1 Z5:6:7 E3)

Any help would be really appreciated I followed all documents but somewhere something is just not right and I know it shouldn't be a huge thing cause I tried with another surely working one and it does the same thing so it's a config matter somewhere...

@droftarts I just got tired of banging my head and followed steps to upgrade to 3.2.2 ...wish me luck...

@droftarts I actually followed all your recommendations, with no luck.
I'm a bit struggling here cause I double-checked the wiring, my bltouch is latst version and should support both 3.3v and 5v, I configured jumper for 3.3 logic and I'm using PWM5 but I cannot get the pin to deploy.
I'll keep trying but I'm starting to think I should upgrade to RRF3 to get better results...

@Agniusm said in Duet Wifi BLTouch wiring:

https://betrue3d.dk/bltouch-on-duet-wifi-configuratio-and-usage/

following as I'm doing same installation too, but I have a duex5 and I'm using PWM5 channel for servo function (so for me it's P5 and not P9, and I prefer to run the M307 line before)