Topics created by Flex3D

@Danal said in Duet3 6Hc + Duex 3Hc with Raspberry 3B+ Wiring Check:

@Flex3D said in Duet3 6Hc + Duex 3Hc with Raspberry 3B+ Wiring Check:

Thanks, it's the same as yours. Switch number 1 is on and the other 3 are on off.

AHA! They sure are. They fooled me the first time I looked at the photo, even enlarged. 🙂

It's no bother.
Now i'm at the cofig.g and having some wired points like my Z Probe is my z Endstop. Can i leave it even blanc or do risk a hot bed crash?

; Endstops
M574 X1 S0 P"io1.in" ; configure active-low endstop for low end on X via pin io1.in
M574 Y1 S0 P"io0.in" ; configure active-low endstop for low end on Y via pin io0.in
M574 Z1 S2 ; configure Z-probe endstop for low end on Z

; Z-Probe
M558 P1 C"io3.in" H5 F120 T6000 ; set Z probe type to unmodulated and the dive height + speeds
G31 P500 X0 Y0 Z2.5 ; set Z probe trigger value, offset and trigger height
M557 X15:300 Y15:300 S20 ; define mesh grid

@droftarts @Danal Thanks. Works like a charme. IMAG0021[1].jpg

Thanks, i will try that later and report back if it worked @Danal

@bearer Thanks, i still thought about the same. If it doesn't work i've to get the 12 volt from an other Pin. A shortage is not possible now, So I'll test it with a metal spachel before if the measuring distance decreased for the reason of 5-5,5 Volt instead of 6.

@Danal Thanks, i would like to get that confirmed from a official before i even would try it.
You may right. If i have the main Power Supply unplugged, i don't see any risk in it. Guarantee wise I still try to be as careful as i can.
I've read a bunch other forum threads and don't want to risk it in case of own made wiring mistakes or processing order Failures.
My preordered Duet 3 Expansion Board didn't arrive even because it's in production up to the end of february. I still have time left make it flawless.