Hi, I think there is no Problem with the Cabel, i tested it with another Duet Wifi with other Cabels, i will take some Photos today in the evening

Hi, Yes i tried different Cables and the soldering Looks good.

Hi there,
I bought a Panel Due 5 last year, the new model, Unfortunately I had to find out that the display is still not woking with the 4 pin. Cabel, I tested it on two duets, it only works with the ribbon cable. Is there a special setting for this?
I have another Panel Due 5, the old version this works with both duets.
I have already contacted the sales service but maybe someone already has a tip.
Greetings from Germany

I have read the doku and changed the config.g as described. Are the files I uploadet not displayed?

Hi, I hope Google Translate it well.
I am currently updating my Sidewinder, he gets Duet Wifi with 5 inch display, sensorless homing and Pinda. I got it started, the probe responds to my Pei plate. Now I have problems with homing. When I drive an axis it drives home but does not stop walking. He rattles at the endstop, as well as the bed.
Homing macro.txt
homez.g
homey.g
homex.g
homeall.g
config.g

Does anyone have a good tip for me.
Greetings from Germany

Ok i will try, Thank you

Ok, can I reset the output from the sensor to 5 volts with a resistor?

Thank you for the answers:-)
Can I do that with the endstops? In the documentary is it about the Z-Probe, or I oversee the part with the Endstops?

Hi everyonbe,
I now intend to upgrade my second printer with a duet In the stock of the Sidwinder X1 I noticed that the endstops with 12 - 24 V work. For this I have attached a picture of the schematic. Is there a way to use them anyway?

Greetings from Germany
-Philipp

Hi, I have now rebuilt my TLM back to micro switch (thanks to the magnetic rods no problem) and started a new calibration, attached the pictures.