Topics created by Gencab

@elmoret Thank you very much for the offer. I had already seen you and Filastruder help another customer in a bad situation with M3D and was already convinced you guys go above and beyond to help out our community. Hopefully M3D does the right thing and finally sends the promised replacement board but in any case i'm a Filastruder customer from here on out. You folks are awesome thank you!

@phaedrux best typo ever. Giggle meant to be jiggle but my brain took the wheel on that one. I can always try the giggle test. 🙂

Giggle test: stare at your printer with intent. Proceed to giggle at it. Record your results. If your printer giggle back call the local law enforcement. or the SCP foundation and let them know SCP-1146 got away.

@resam said in Wrong gcode to finish a print?:

G91 only affects the X/Y/Z axis.

You want M83: https://duet3d.dozuki.com/Wiki/Gcode#Section_M83_Set_extruder_to_relative_mode

@resam
(facepalm) that makes things much more clear. Thanks for the assist. Bookmarking that page full of goodness.

Glad you got it sorted.