Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
Please post your bed.g file, and the GCode commands that do the purging if they are in a different file.
Does the problem still occur if you don't do the purge?
figured it out, it was also a strange setting that was in simplify3d. printing well so far, the true test will start tonight.
Hey all,
Not sure what happened, but I have not had a disconnect in a few hours, so maybe the new firmware is doing its job. If I find anything out I will report back to this thread.
Thanks,
