Topics created by heinrich.platau

@jay_s_uk

You are right!! Problem solved!

I thought about the worst case but I'd better check the most obvious error.

Thanks.

Thread can be closed!

@heinrich-platau I had also this message after the first tuning. Try to run the tuning again.

Not yet. Moved to the wishlist.

@Veti said in BLTouch Pin won't come out:

M106 P0 C"Druckteil-Kühler" S0 H1 T200

you want

M106 P0 C"Druckteil-Kühler" S0 H-1

this allows the slicer to control the fan with the M106 command.

if you have a buck converted you can use 12v fans with the duet.
if you connect 12v to the v_fan selector pin.
see https://cdn.thingiverse.com/assets/aa/49/81/b2/23/wiring_12v_fan_on_24v_system-min.jpg

The current for my motors? It's 800 mA for each motor. That's the default in configtool.... I haven't tuned them so far. Do you have another suggestion for default setting for the current?

go for 75% of the rated current of the motors.

@heinrich-platau said in Issues to switch ON / OFF the heated Bed:

@fcwilt Thank you Frederick.

Now, after auto tuning, the heating bed works fine.

Glad we were able to help.

Frederick