Topics created by Impalanator

Cancel this one, I was on Buster and not Bookworm. I followed this:
https://docs.duet3d.com/en/How_to_guides/SBC_Buster_to_Bookworm

And now it is working fine on 3.5.2.

Thanks,
Ed

@Phaedrux just reporting back that it was definitely the issue. Once I drilled the holes out in the case and re-mounted the PanelDue, the issue was fixed. Thanks!

@arnold_r_clark
That was it exactly, thank you!

12/19/2021, 2:29:38 PM G32 Leadscrew adjustments made: 0.001 0.005, points used 2, (mean, deviation) before (0.003, 0.001) after (0.000, 0.000) 12/19/2021, 2:29:02 PM G32 Leadscrew adjustments made: 0.008 -0.005, points used 2, (mean, deviation) before (0.002, 0.004) after (-0.000, 0.000) 12/19/2021, 2:28:28 PM G32 Leadscrew adjustments made: 0.015 -0.016, points used 2, (mean, deviation) before (0.001, 0.011) after (-0.000, 0.000) 12/19/2021, 2:27:56 PM G32 Leadscrew adjustments made: -0.023 -0.281, points used 2, (mean, deviation) before (-0.140, 0.089) after (0.000, 0.000)

@droftarts Thanks, this is exactly what I was looking for.

Ignore this one please. I can't delete it. I rephrased the posted a better question here:
https://forum.duet3d.com/post/230220

@dc42 Thanks! I put the glass bed on before the tuning exercise so the temp of the surface of the bed matches what is displayed in the Duet3d WebUI. It is less than a degree off at both 60 degrees Celsius and 110 degrees Celsius, within the error margin of my thermometer. I am very happy with the results .

@phaedrux Thanks! I will check out that plugin. It looks like the firmware now gets installed automatically when you upload the files without asking you to install it as well.