@Phaedrux I will for sure give this a shot, but im 99% sure its not due to the weight. The weight has never been an issue before, its only when the bed is at the bottom. If I try to "hold" the bed with my finger below it when it has no current I can simply hold my finger there without giving any preassure and it stays.
@droftarts This sounds like the solution! After changing parts on the printer lately I have for sure gained more Z travel and I intentinally set that limits to be lower earlier as the bed struggled when going all the way down(slightly skewed Z rods).
I will post back in a couple of minutes with an edit
Edit: It was the Z axis limit that caused this. Now it works as intended even at the lowest point it can reach. I did not think about this at all until I read out your message
Thanks alot to both of you! Im starting to get close to a result I can be happy with