Topics created by Jaran

@OwenD said in Modified Ender 3 V2 - Stripes on the side of the print:

it never realised the promise of higher print speeds on the bed slinger for me.

That's why I said it wouldn't hurt to use a direct drive on a bed slinger. Their speed limitter is the heavy bed. Especially with a halfling NEMA17 motor on the Y-axis.

@dc42 I will update the firmware right away. Been a while sinse I updated last.

Thanks alot for the explanation. You were 100% right! I was a bit too quick to overlook that 🤠

It triggered right away when I reduced the H parameter.

Thanks again 🙂

@droftarts Aha, I see.

The probe did trigger. The bed kept moving until it hit the probe no matter how far down it was. It did not stop at the bottom, it kept on going and grinding the motors.

@dc42 I have it working now, but yes, they sure did! Been a while sinse I sat up the first one. It has a LCD display where you can dial in the voltage and then adjust it with the voltage pot. I might have done something wrong, but I ended up with 5V on the display as output when I actually reached 12V output while adjusting the voltage adjustment pot.

Thanks though!

Back to the drawingboard! Seems like im having the exact same issues with the dimensions when I printed the hexagon. The only change I made was swapping out the filament.

I saw that the belt seem to have the same angle as the old parts. I tried to import the parts into fusion to see how they lined up:
0891d580-ef14-4545-9eb8-5f8c67598b55-image.png

It does not look like the parts are fully lined up. If you look at the right side of the picture you can see the outline of the hole the belt goes into. The line is going from the top of that hole to a bit over center on the idler. Is this enough to make up the problems im having? I just find it weird how nobody else with the design have pointed it out 😕

Is there a way I can verify that it actually is the belt doing it? If I loosen one belt and tighten the other, and vice versa I should see some changes on the dimensions depending on which belt is tight/loose?