Topics created by Kediil

Makes more sense with the heater having failed as well, but again suspect a short in the hotend wirng as root cause for both boards having issues.

Removing D1 might mess up the power fail detection, which is why I suggested removing L2 instead - however if you don't need the resume on power loss functionality then it doesn't matter.

@Kediil said in Sudden perma hotend heater fault?:

The casing on the heater spot on the board wiggles,

Can you post a video of what you mean by this?

@Phaedrux Absolutely. Honestly, I was trying to get everything printing efficiently before learning how to actively use the probe! I had been having an issue with a solid mount that didn't move the probe when I changed out a nozzle too, but that has, luckily, been remedied as well. 🙂

Thank you!