Topics created by kostasbmw

i did the correction to the endstops mannually because in the configurator i have the choice of low and high end and that is what i did....maybe there is something i did nt do
now i home all axis ......
i copied all my previous mumbers to the new config and i m checking the behaviour of the printer

thanks for your assistance .....untill the next problem....

The DWC version can also be found in the settings page of DWC.

home x and y solved ......i changed the wiring and now the endstops work

crazy.....i m going through the cable to see for a broken part

also i moved back to original position the x endstop because the drive for x is on E1....and i had the endstop above E1

so far so good...untill next problem
thanks for your time @Veti

@kostasbmw said in cura start gcode help:

ok i did that and the heater started heating nicely
but i need about 1 minute before starts printing(thats how much time i need to get noozle to 200)
is there a way to hold somehow the printing after bed heating + levelling so i have my noozle ready to desire temp???

Change the M109 command to use the first layer temperature, and remove the M104 command that is 2 lines later.

yes
i was so stupid i took no back up from the sd before upgrading
anyway i formatted a new card and did everything from scratch..
i m connected i have the config file i saved and continuing with the calibration of the x y axis.....thanks anyway

@dc42
thanks